The weather was perfect for painting and my motivation level was high. As a result, last few days have been a nice steady stream of Thunderbird work.
I hit the firewall, brake booster and master cylinder with POR-15 paint prep, which magically neutralizes rust. The instructions have you spray it on, then keep the area damp with it for around 30 minutes. In warm weather and direct sun, that was a lot of spraying. Afterwards, the solution is washed off with water, which always seemed a bit odd in a rust preventative. I toweled off what I could and left it to dry.
I masked as best I could and used old bedsheets as additional insurance. The tiny spray pattern doesn’t allow for much overspray, so this was a little overkill.
The following morning was overcast, but windless, dry, and warm (actually really odd weather for us). The flat light made it a bit difficult to see, but I got a relatively smooth first coat down. (I really wanted one coat to be good enough, but once it was dry and the spray gun cleaned, I could see thin spots and unevenness. Once I did, I couldn’t rationalize leaving it as is.)
This morning was sunny, but no wind, so I donned my respirator, re-draped the old bedsheet tarps and climbed into the engine bay for the last spray. I turned up the product on the gun to improve the coverage a bit.
The second coat went fast, and I ended up with a nice satin finish (glossy paint + the rough surface of the firewall) that I rather like. I used POR-15 engine paint–the same that I used on the motor. It’s durable and easy to touch up.
There’s one last item before I’m ready to install the engine, and that welding in a small oxygen sensor bung on the exhaust pipe. It will be plugged for now, but it’s the first step on the road to electronic fuel injection.